E CUBE.my
Network & CCTV事件地点未注明

QNAP Clarifies: Thunderbolt Port MTU Is Fixed at 65522, No Jumbo Frame Setting Needed

A QNAP support article explains that on Thunderbolt-equipped NAS models such as the TVS-h674T, the Thunderbolt network interface uses a fixed MTU of 65522 under IP over Thunderbolt, so no Jumbo Frame option appears in Network & Virtual Switch. This is by design, not a missing setting or defect.

Source QNAP · 2026-11-11Reading time 2 min

Key points

  • Applies to QNAP Thunderbolt NAS models (e.g., TVS-h674T and other Thunderbolt-equipped units) running QuTS hero or QTS.
  • The Thunderbolt network interface operates over IP over Thunderbolt with a fixed MTU of 65522, which cannot be edited in the NAS GUI.
  • Because 65522 far exceeds the common Jumbo Frame standard of 9000, the NAS side is never the frame-size bottleneck on the link.
  • The effective frame size is negotiated as the smaller of the two endpoints' MTU values; to use larger frames, adjust the MTU on the client-side Thunderbolt interface.
  • Users can view the current Thunderbolt interface MTU in read-only mode for reference, but it cannot be changed.

2026-11-14 | 事件地点未注明 | Source: QNAP (2026-11-11). QNAP published a technical FAQ on its ASEAN support site (dated 11 November 2026) addressing a common question from users of its Thunderbolt NAS line: why there is no option to set Jumbo Frames (MTU 9000) on the Thunderbolt ports. The article states plainly that the absence of such an option in Network & Virtual Switch is expected behaviour, not a missing setting or a product defect.

The underlying reason is architectural. On QNAP Thunderbolt NAS models — the TVS-h674T is cited as an example, with other Thunderbolt-equipped units covered as well — the Thunderbolt network interface runs over IP over Thunderbolt and carries a fixed MTU of 65522. That value is more than seven times the typical Jumbo Frame size of 9000, so the NAS end of the link can never be the limiting factor for frame size.

The article explains how the effective frame size on a Thunderbolt link is determined: it is negotiated as the smaller of the two endpoints' MTU values. If a user wants to push larger frames across the link, the correct place to make the change is on the client side — the Thunderbolt interface on the device connected to the NAS. No adjustment is needed or possible on the NAS itself.

For users who simply want to confirm the current MTU of their Thunderbolt interface, QNAP notes that the value can be viewed in read-only mode within the system for reference purposes only; it cannot be edited through the GUI. The article also directs readers with further questions to the QNAP Community forum, where QNAP staff and experienced users provide answers.

It is worth noting that this is a product-usage clarification, not a security advisory or firmware update notice. The article does not reference any CVE, vulnerability identifier, or patch.

What it means for Malaysia

Malaysian professionals and SME IT administrators who pair a QNAP Thunderbolt NAS (such as the TVS-h674T) with workstations for video editing, large-file transfers, or high-throughput storage can save troubleshooting time by knowing upfront that the NAS-side MTU is fixed at 65522. If link performance falls short of expectations, the first place to check should be the client-side Thunderbolt interface MTU setting rather than hunting for a non-existent option in the NAS GUI.

Original sources

This story is our own write-up based on the reports below. Last reviewed 2026-11-20